Great advice! I couldn’t agree more. It saved me so much headache when I did my conversion last year. Worth the extra effort!
7 Likes
A major challenge I faced was tuning the ECM after the conversion. It requires specific adjustments to get the best performance out of the Vortec. Make sure to do your research on the tuning process!
Exactly! If your ECU doesn’t play nice, you’ll be stuck with a subpar setup. I learned the hard way that taking it to a pro can save time and stress.
1 Like
Support is key! You can always find resources or forums like this to ask questions. Just don’t jump in without doing your homework first.
1 Like
Couldn’t agree more! The online community is invaluable during these conversions. Cheers to everyone sharing their experiences!
I recently completed my TBI to Vortec conversion, and I was surprised by the rough idle I encountered. Has anyone else faced this issue?
Yes, I had a rough idle too! I found adjusting the idle air control valve really helps even things out. Don’t forget to check your timing as well!
1 Like
Sometimes, a rough idle can stem from improperly connected vacuum lines. Make sure all connections are sealed tight to avoid any leaks that could throw off your engine’s performance.
8 Likes
Good point! I had a vacuum leak that caused all sorts of problems. A smoke test can really help identify those sneaky leaks.
Performance tuning after the conversion is crucial! I recommend using an O2 sensor and a wideband gauge to fine-tune the air-fuel mixture for optimal performance.
Great advice! I didn’t have a wideband gauge initially and regretted it. The difference in performance was noticeable once I used one.
Is anyone else dealing with electrical gremlins post-conversion? My check engine light keeps flickering, and I suspect it’s a wiring issue.
I faced similar problems! Double-check your grounds. A bad ground can cause all kinds of erratic electrical behavior.
I did the conversion last month, and I can’t emphasize how important it is to reset your computer after finishing the install. It helps clear any old trouble codes.
Totally agree! I was troubleshooting for days until I realized my computer needed a reset. It’s a simple step but can save you a lot of headaches.
Just don’t forget, keeping a good sense of humor while solving these issues is key! I’ve had moments where I felt like throwing wrenches but laughter saved the day.
4 Likes