I used plastic sheeting and it worked well! Just make sure it’s thick enough to last awhile.
Don’t forget to use a heat gun or a hairdryer to smooth out the plastic before sealing. It really makes a difference!
Great tip! I wish I had thought of that. It would have saved me a lot of hassle!
This guide is so helpful! I was about to take my car to a mechanic, but I might give this a try myself now.
You can totally do it! Just be patient and follow the steps carefully - or else you’ll end up with a door that sounds like a submarine!
2 Likes
Has anyone tried using different adhesive for the new vapor barrier? I’m curious if there’s something better than the standard.
I used silicone adhesive and it worked nicely! Just make sure it’s waterproof!
I had such a difficult time during my first try. I think I spent more time cleaning than actually doing the job!
Experience is the best teacher! Each time you do it, you’ll get a bit better.
I recently had an issue with water pooling in my car door. The vapor barrier was ripped. I found a great tutorial online for repair! Highly recommend it.
What tutorial did you use? I’m considering fixing mine too and would love some guidance.
A few months ago, I noticed my door trim was wet after rain. Turns out my barrier was peeling off. I used some strong adhesive to fix it and it’s held up well.
That’s a great tip! Did you use any specific adhesive? I want to make sure I get the right one.
8 Likes
I ended up replacing the entire vapor barrier on my car. It was a bit costly, but worth it in the long run. No more leaks!
What did you use to seal the new barrier? I want to avoid issues again.
If anyone’s thinking about doing this, just know it’s not as complicated as it sounds. Just take your time and follow the steps gradually!
3 Likes
True! I was so intimidated at first, but it really wasn’t bad. Just be prepared for some sticky situations—literally!
My vapor barrier is so old, I’m worried it might just fall apart one day. Is there a recommended replacement part I could get?
Check with your car manufacturer. They usually have the best parts, especially if you have an older model.
I had a hilarious experience with mine. I thought I could just tape it and it worked—for about a week. Lesson learned!